| อะไหล่(24 H)-ฟิโอนา |  |
| อุปกรณ์-ลี | |
| วัสดุสิ้นเปลืองการบํารุงรักษา - เจสสิก้า | |
We know how frustrating it is to unpack a brand new Yamaha i-Pulse F3 feeder and think it’s faulty. The truth? Over 95% of “faulty” feeders we receive are actually in perfect condition—the issue is usually a simple adjustment or cleaning.
This step-by-step guide will help you check your feeder before sending it back, saving you downtime and shipping costs.
Goal: Confirm feeder alignment, sensor accuracy, and smooth feeding.
How to:
Mount the feeder on your feeder calibration unit.
Run the standard test cycle.
Watch for smooth movement and consistent component indexing.
Our Example:
When we tested a returned F3-8mm feeder, calibration results showed no errors.
Feeding problems often happen because the pitch setting isn’t correct.
Options:
Use your machine’s built-in pitch adjustment (usually located on the left side).
Use an OFFLINE SETUP ST LG4-MMC00-000 unit for precise adjustment.
Recommended Pitch for F3-8mm Feeder:
Set to เลข 4 ขว้าง.
After pitch adjustment:
Install the feeder on the SMT machine (e.g., เอ็ม10).
Run at least 3 consecutive test cycles.
Check for consistent feeding and no misalignment.
Our Example:
We ran 3 tests on an M10 machine—no abnormalities found.
Even a perfect feeder will fail if the base station is dirty.
Check for:
Tape scraps
Dust or lint
Small metal shavings
Clean with an anti-static brush or compressed air.
Original Yamaha feeders store component count data:
Example from Returned Feeder:
Available components: 1,000,000
Remaining: 1,000,000
Translation? This feeder is essentially brand new—mechanical failure is unlikely.
| Symptom | Likely Cause | สารละลาย |
|---|---|---|
| Skips components | Pitch set incorrectly | Adjust to No. 4 ขว้าง |
| Feeds unevenly | Dirt on base station | Clean station with brush/compressed air |
| Stops feeding after a few parts | Wrong calibration | Test & recalibrate on feeder calibration unit |
| No movement at all | Feeder not seated properly | Reseat and lock feeder in place |
Original Yamaha i-Pulse feeders are extremely reliable.
Before assuming yours is faulty:
✅ Calibrate it
✅ Set the correct pitch
✅ Test multiple times
✅ Clean the base station
If you still have problems after following these steps, contact us with:
Feeder model & serial number
Video of the issue
Machine model & pitch setting
We’ll help you solve it—fast.